Login
Home


Individual Forming Solutions
Individual Forming Solutions

Stamping

High performance oil for severe stamping operations, contains chlorine
Physical Properties Typical Data
Parameter Typical results Tested according to
Appearance: Light brown, clear Visual
Density at 68°F: 1.00 g/cm3 ASTM D 7042
Viscosity at 104°F: 36.0 mm2/s ASTM D 7042
Flash point: > 302 °F DIN EN ISO 2719
Copper corrosion: 1a DIN 51759-1
Stamping oil for the textile industry etc, chlorine free
Physical Properties Typical Data
Parameter Typical results Tested according to
Appearance: Yellowish, clear Visual
Density at 68°F: 0.87 g/cm3 ASTM D 7042
Viscosity at 104°F: 50.0 mm2/s ASTM D 7042
Flash point: > 329 °F DIN EN ISO 2719
Copper corrosion: 1b DIN 51759-1

Deep drawing

VDA approved prelube for the automotive industry or kitchenware/ appliances
Physical Properties Typical Data
Parameter Typical results Tested according to
Appearance: Medium brown, clear Visual
Density at 59°F: 0.91 g/cm3 ASTM D 7042
Viscosity at 104°F: 120.0 mm2/s ASTM D 7042
Flash point: > 374 °F DIN EN ISO 2719
Film type: Oily Haptical
Removability (1.7 g/m2): Fulfilled VW-52.01/VDA 230-201
Draining behavior (after 24 h) Fulfilled VW-PV 52.03/VDA 230-201
Humidity test: 30 cycles DIN EN ISO 6270-2 AHT
Salt spray performance: 6 h DIN EN ISO 9227 NSS
For drawing of brass cases, water-miscible
Physical Properties Typical Data
Concentrate
Color Mineral oil content Viscosity at 68°F:
ASTM D 7042
Density at 68°F:
ASTM D 7042
Copper corrosion:
DIN 51759-1
Brown Free 315.0 cSt 0.98 No attack
5% Solution
Color pH-value
(tap water)
Corrosion protection
DIN 51360-2
Refractometer factor (brix) Conductivity
(Deionized water)
Yellowish 9.5 5 % grade 0 1.0 Not determined
Characteristics
Mineral oil EP-additives Chlorine Boron Amines FAD
- + - - - -

Tube drawing

For copper and copper-iron alloys
Physical Properties Typical Data
Parameter Typical results Tested according to
Appearance: Clear Visual
Density at 68°F: 0.90 g/cm3 ASTM D 7042
Viscosity at 104°F: 2780.0 mm2/s ASTM D 7042
Flash point: > 320 °F DIN EN ISO 2719
Copper corrosion: 1a DIN 51759-1
For drawing of tubes with small diameters (e.g. for diesel injection lines)
Physical Properties Typical Data
Parameter Typical results Tested according to
Appearance: Brown, clear Visual
Density at 68°F: 0.90 g/cm3 ASTM D 7042
Viscosity at 104°F: 90.0 mm2/s ASTM D 7042
Flash point: > 428 °F DIN EN ISO 2719
Copper corrosion: 1b DIN 51759-1